Relay Health Setup Guide - Step 5
Create an EDI Receiver in Medisoft
- Open your Medisoft program and log into your practice
- Click Lists then select EDI Receivers
- Click New
- In the Address Tab, fill in the following information:
- Name: enter "RelayHealth"
- Extension: If you receive ERA files, enter "ST:"
- In the Modem Tab, fill in the following information:
- Transmission Mode: select "Active"
- In the ID Tab, fill in the following information:
- Submitter ID 1 — Enter your RelayHealth EMF Login.
- Submitter ID 2 — Enter your RelayHealth Billing ID plus the RelayHealth Submitter ID.
- Do not put any spaces between the two series of numbers. For instance, if your Billing ID equals 9999 and your Submitter ID equals 001234, then you would enter 9999001234.
- Submitter Password 1: Enter the EMF Password.
- Submitter Password 2: Leave blank.
- Program File: Enter "RELAYH".
- File Path and File Name: Leave these fields blank.
- Group Practice: If you are a group practice, click this box.
- Interchange Receiver ID: Leave this field blank.
- Interchange Sender ID: Leave this field blank.
- Vendor ID: Leave this field blank.
- In the Extras Tab, fill in the following information:
- Office Contact: Enter the name of the contact person in your office.
- Application Receiver Code: Leave this field blank.
- Application Sender Code: Leave this field blank.
- Region: Leave this field blank.
- Receiver Type: Leave this field blank.
- Entity Type: If you are a group practice, select "non-person" otherwise select "person"
- All Remain Fields: Leave blank
- Click Save